Rear Wheel Speed Sensor: Removal
WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Remove the wheel and tire.
- Release the wheel arch liner.
- Remove the 5 screws.
- Disconnect the rear wheel speed sensor electrical connector.
- Open the electrical connector housing.
- Release the electrical connector from the clip.
- Remove the rear wheel speed sensor.
- Release the wiring harness from the 5 clips.
- Remove the bolt.