FixVault
Home › Land Rover › 2006 › Range Rover Sport HSE › Repair and Diagnosis › External Pages › Different variant/trim › Section 10 (Speed Control - 4.2L) › Speed Control - V8 S/C 4.2L Petrol › Removal And Installation › Speed Control Module › Installation

Speed Control Module: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the speed control module.
    • Connect and secure the electrical connector.
    • Tighten the bolt to 10 Nm (7 lb.ft).
  2. Install the Dynamic Response module. Refer to Dynamic Response Module .
  3. Connect the battery ground cable. Refer to Specifications .
  4. Program a new control module using T4.
About FixVault