Powertrain Control Module (Pcm) Short Drive Cycle Self-Test
NOTE:
This procedure is an overcheck only. If fault codes are found, interrogation of the relevant system must be carried out and claimed against.
- Connect the diagnostic equipment to the vehicle.
- Follow on screen prompts and check for engine management fault codes.
- Clear the fault codes following the on screen procedure.
- Start the engine.
- Allow the engine to idle for 30 seconds.
- Raise the engine speed to 1500 rpm and hold for 3 minutes until a temperature of 70°C (158 °F) is achieved.
- Allow the engine to idle for 30 seconds.
- Switch off the engine.
- Follow on screen prompts and check for engine management fault codes.
- Disconnect the diagnostic equipment from the vehicle.
NOTE:
If fault codes are found, interrogation of the relevant system must be carried out and claimed against.