FixVault
Home › Land Rover › 2008 › Range Rover Westminster › Repair and Diagnosis (Single Page) › Accessories & Equipment › Infotainment › Navigation System › Navigation System › Removal And Installation › Navigation System Traffic Module › Installation

Navigation System Traffic Module: Installation

  1. Install the navigation system traffic module.
    • Tighten the 2 nuts to 10 Nm (7 lb.ft).
  2. Connect the navigation system module optical connector.
  3. Connect the navigation system traffic module coaxial cable connector.
  4. Connect the navigation system traffic module electrical connector.
  5. Install the access panel to the loadspace trim panel LH.
  6. Connect the battery ground cable. Refer to Specifications .
  7. Using the Land Rover approved diagnostic system, follow the on-screen instructions and configure the navigation system traffic module.
About FixVault