FixVault
Home › Land Rover › 2012 › LR2 Base › Repair and Diagnosis › Electrical › Gauges › Instrument Panel And Console › Instrument Panel And Console › Removal And Installation › Instrument Panel › Installation

Instrument Panel: Installation

    • Install and tighten the M8 bolts.

      Torque: 24 Nm

    • Install and tighten the M12 bolts.

      Torque: 40 Nm

    • Install the 2 screws.
    • Remove protective tape and covers.
    • Install the bolt covers.
  2. Install the windshield defroster outer finishers.
  3. Install the heater housing bolt.
  4. Install the heater core inlet and outlet hoses.
  5. Remove the coolant hose clamps.
  6. Connect the A/C pipes to the TXV and tighten the M6 nut.

    Torque: 10 Nm

  7. Install the ECM bracket assembly and tighten the nuts.

    Torque: 10 Nm

  8. Connect the ECM electrical connectors.
    9. WARNING: Make sure that a new bolt is installed.
  9. Connect the steering column lower shaft and tighten the bolt.

    Torque: 25 Nm

  10. Connect the drain tube to the heater housing.
  11. Secure the redundant electric booster heater electrical connector.
  12. Install the center, lower ducts to the heater housing.
  13. Install the NVH pad.
  14. Install the instrument panel wiring harness.
  15. Install the auxiliary junction box access cover.
  16. Secure the instrument panel harness to the transmission tunnel.
  17. Secure and tighten the earth lead.

    Torque: 10 Nm

  18. Connect the body harness to the instrument panel.
  19. Install the floor console extensions.
  20. Install the selector lever mounting bracket.
  21. Install the transmission selector lever. Refer to SELECTOR LEVER .
  22. Install the LH front seat. Refer to FRONT SEAT .
  23. Install both cowl side trim panels. Refer to COWL SIDE TRIM PANEL .
  24. Secure both scuff plate trim panels.
  25. Install the A-pillar center trim panels.
  26. Install both A-pillar upper trim panels. Refer to A-PILLAR TRIM PANEL .
  27. Install both front door assemblies. Refer to FRONT DOOR .
  28. Recharge the A/C system. Refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
  29. Install the windshield wiper motor. Refer to WINDSHIELD WIPER MOTOR .
  30. Connect the battery ground cable. Refer to SPECIFICATIONS .
  31. Check and top-up the coolant.
About FixVault