Removal And Installation: Installation
WARNING: This page is about a different car, the 2018 Jaguar XF, 2017 Jaguar XF, and 2016 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
-
- Install the blindspot monitoring control module (BMCM).
- Tighten the bolt.
Torque Specification: 1.9 Nm
-
- Install the blindspot monitoring control module (BMCM) assembly.
- Tighten the 2 bolts.
Torque Specification: 1.9 Nm
- Connect the electrical connector.
- Install the rear bumper.
Refer to: Rear Bumper .
- Connect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .
- If a new component has been installed, configure using Jaguar approved diagnostic equipment.
General Equipment: Jaguar diagnostic equipment