FixVault
Home › Land Rover › 2012 › LR4 Base › Repair and Diagnosis › Engine Performance › Engine Control Systems › Electronic Engine Controls › Electronic Engine Controls - V8 5.0L Petrol › General Procedures › Brake Pedal Position (BPP) Switch Adjustment › Adjust

Brake Pedal Position (BPP) Switch Adjustment: Adjust

    CAUTION: The brake pedal must not  be pressed during this operation. Failure to follow this instruction may result in damage to the component.
    CAUTION:
  1. Remove the stoplamp switch. Refer to Stoplamp Switch .
    2. CAUTION: The brake pedal must not  be pressed during this operation. Failure to follow this instruction may result in damage to the component.
    CAUTION: Only use light finger pressure when installing the stoplamp switch. Failure to follow this instruction may result in an incorrectly adjusted stoplamp switch.
  2. Install the stoplamp switch. Refer to Stoplamp Switch .
  3. Check the adjustment of the stoplamp switch by following the Check  procedure in this procedure and carry out the Adjust  procedure if required.
About FixVault