DTC B0005-13: Collapsible Steering Column Deployment Control - Circuit open: Action
WARNING: This page is about a different car, the 2018 Jaguar XF, 2017 Jaguar XF, and 2016 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not measure the resistance of a deployable device using any other method than that described below.
NOTE:
Steering column collapse actuator resistance specification is 1.70 ohms to 2.30 ohms at -40°C to 85°C.
- Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Deployment Control 4 Resistance (0x5B07). Refer to the appropriate system wiring diagrams and check the steering column collapse actuator circuit for open circuit, high resistance
- Disconnect the steering column collapse actuator connector and apply light pressure to the connector plunger. If the plunger moves to the engaged position the connector is damaged. Install a new wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new steering column collapse actuator