Front Drive HALFSHAFTS: Specifications
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATION
| Item | Specification |
|---|---|
| Type | Fully floating, fixed length, solid shafts incorporating constant velocity joints at each end of shaft |
RECOMMENDED LUBRICANT
| Item | Specification |
|---|---|
| Outboard joint | Use grease supplied with replacement boot kit (Optimol MS139G) |
| Inboard joint | Use grease supplied with replacement boot kit (1 Luber C MS132G) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| * Stabilizer bar link nuts | 115 | 85 |
| * Stabilizer bar link nuts - vehicles with Dynamic Response | 175 | 129 |
| * Upper arm to wheel knuckle nut | 70 | 52 |
| * Tie rod end ball joint nut | 76 | 56 |
| Brake hose retaining bracket to wheel knuckle bolt | 25 | 18 |
| *+ Halfshaft retaining nut | 230 | 169 |
| Road wheel nuts | 140 | 103 |
* New nut must be installed
+ Stake nut on completion