FixVault
Home › Land Rover › 2013 › LR4 Base › Repair and Diagnosis (Single Page) › Engine Performance › Engine Control Systems › Acceleration Control › Acceleration Control › Accelerator Pedal - Removal and Installation › Removal

Accelerator Pedal - Removal and Installation: Removal

  1. Remove the driver side closing trim panel.
    • Release the clip.
    • Remove the 2 screws.
    • Disconnect the electrical connector.
    GJ0013763
  2. Remove the accelerator pedal assembly.
    • Release the wiring harness.
    • Remove the 3 nuts.
    • Disconnect the electrical connector.
    GJ0014581
    3. NOTE: Do not disassemble further if the component is removed for access only.
  3. Remove the accelerator pedal bracket.
    • Remove the 3 nuts and bolts.
    GJ0014582
About FixVault