FixVault
Home › Land Rover › 2014 › LR4 Base, AWD › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock Control - Traction Control -- LR4/L319 › Anti-Lock Control - Traction Control › Front Wheel Speed Sensor › Removal And Installation › Installation

Removal And Installation: Installation

  1. Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
  2. NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.

    Install the wheel speed sensor.

    • Connect the electrical connector.
    • Attach the wiring harness to the 5 clips.
    • Tighten the bolt to 9 Nm (7 lb.ft).
  3. Secure the brake caliper and anchor plate to the wheel knuckle.
    • Tighten the bolts to 275 Nm (203 lb.ft).
  4. Secure the brake hose retaining bracket to the wheel knuckle.
    • Tighten the bolt to 25 Nm (18 lb.ft).
  5. Install the fender splash shield.

    For additional information, refer to: Fender Splash Shield .

  6. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
  7. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
  8. If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
About FixVault