FixVault
Home › Lexus › 1992 › LS 400 › Repair and Diagnosis › External Pages › Different car › Section 1 (Air Bag Restraint System) › Trouble Shooting › Code 64

Code 64

WARNING: This page is about a different car, the 1994 Lexus LS 400. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During testing, if codes other than Code 64 are displayed, disregard them.
  1. Disconnect negative battery cable. Wait at least 90 seconds. Remove steering wheel pad. See STEERING WHEEL PAD & SPIRAL CABLE  under REMOVAL & INSTALLATION. Disconnect passenger-side air bag harness connector, accessible through finish plate in glove box. See Figure. Disconnect seat belt pretensioner connectors. Ensure cover is securely installed onto seat belt pretensioner check connector located under right rear seat. See Figure.
  2. Disconnect center air bag sensor connector. Measure resistance between terminals of left seat belt pretensioner connector (harness side). If resistance is less than one ohm, go to step 5). If resistance is one ohm or more, remove cover from seat belt pretensioner check connector.
  3. Measure resistance between terminals of left seat belt pretensioner connector (harness side). If resistance is one ohm or more, replace harness between left seat belt pretensioner and seat belt pretensioner check connector.
  4. If resistance is less than one ohm, measure resistance between terminals No. 5 and 8 of seat belt pretensioner check connector. If resistance is one ohm or more, replace harness between center air bag sensor and seat belt pretensioner check connector. If resistance is less than one ohm, go to next step.
  5. Connect center air bag sensor connector. Securely install cover onto seat belt pretensioner check connector. Connect jumper wire between terminals of spiral cable upper connector, passenger-side air bag connector and both seat belt pretensioner connectors (harness side of each connector).
  6. Reconnect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear codes. See CLEARING CODES  under SELF-DIAGNOSTIC SYSTEM. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds.
  7. Connect jumper wire between terminals Tc and E1 of DLC. See Figure. If Code 64 is not displayed, go to next step. If Code 64 is displayed, replace center air bag sensor.
  8. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Connect left seat belt pretensioner connector. Reconnect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear codes. See CLEARING CODES  under SELF-DIAGNOSTIC SYSTEM.
  9. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Connect jumper wire between terminals Tc and E1 of DLC. See Figure. If Code 64 is displayed, replace left seat belt pretensioner. If Code 64 is not displayed, check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT  under DIAGNOSIS & TESTING.
About FixVault