Driver's Door

Disconnect the connector from the master switch.
Connect the positive (+) lead from the battery to terminal 9 and the negative (-) lead to terminal 10 on the wire harness side connector and raise the window to full closed position. See Fig 1.
Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.
Reverse the polarity, check that the window begins to descend within approximately 60 seconds. If operation is not as specified, replace the motor. See Fig 2.

Fig 1: Testing Driver's Side Circuit Breaker Operation (1 Of 2)

Fig 2: Testing Driver's Side Circuit Breaker Operation (2 Of 2)