FixVault
Home › Lexus › 1993 › GS 300 › Repair and Diagnosis › Body & Frame › Power Windows › Removal & Installation › Window Motor & Regulator Assembly

Window Motor & Regulator Assembly

NOTE: Power window motor and regulator must be removed as an assembly. Motor can then be replaced separately. Unless otherwise noted, removal and installation procedures for front and rear power window motor and regulator assemblies are similar.
  1. Disconnect negative battery cable. Remove inside door handle bezel. On driver's door and right front door, carefully pry up on the forward end of power window switch assembly, releasing retaining clip. Pull switch assembly upward and rearward. On rear doors, power window switch may be left in door trim panel. Unplug switch connector and remove switch assembly.
  2. Using taped screwdriver, remove courtesy light and unplug connector. Remove upper speaker at window trim bezel. Remove door trim panel. Remove door speaker assembly. Remove screws securing window to regulator. Using a shop towel, secure window away from regulator.
  3. Unplug power window motor connector. Remove 7 regulator retaining nuts. Remove power window motor and regulator assembly. To install, reverse removal procedure.
About FixVault