FixVault
Home › Lexus › 1994 › GS 300 › Repair and Diagnosis › Steering › Power Steering › Steering System - Electronic › Testing › Component Test › Power Steering ECU

Power Steering ECU

  1. Raise and support vehicle. Remove instrument panel undercover. DO NOT disconnect ECU connector. Start engine. Using DVOM, measure voltage between ECU harness connector terminals SOL (-) and ground with engine idling. See Figure. DVOM should indicate .33-.43 volt.
  2. Place transmission in gear. Increase indicated vehicle speed to 37 MPH. DVOM should now indicate .13-.26 volt. If voltage is not as specified, replace ECU.
About FixVault