Using ABS Warning Light
- Disconnect short pin from Data Link Connector No. 1 (DLC1). See Figure. DLC1 is located in engine compartment, next to oil fill cap. Using a jumper wire, connect terminals Tc and E1 of Data Link Connector No. 1 (DLC1). See Figure.
- Turn ignition on. With vehicle stopped, press brake pedal 8 or more times within 5 seconds. DTCs should now be cleared. Verify ABS DTCs have been cleared and normal code is present. During normal code, 2 seconds will elapse, and then ABS warning light will blink once every .25 second. Turn ignition off. Remove fused jumper wire from DLC1.
NOTE:
Replacing or repairing wheel sensors will not clear codes. Car must be driven to allow ECU to perform primary check. ECU-B fuse removal will clear DTC, but other memory systems will also be cleared.