Test K: Multi-Information Display Screen Does Not Change When Steering Pad Switch Is Operated

1. Check the combination meter assembly:
   • Check the voltage. Remove the combination meter assembly with the connector still connected. See Fig 1. Turn the ignition switch to ON. Measure the voltage between terminal No. C8-18 of the combination meter assembly connector and body ground. See COMBINATION METER STANDARD VOLTAGE  table. See CONNECTOR IDENTIFICATION .
     COMBINATION METER STANDARD VOLTAGE
     
     

     Condition	Voltage
     MODE Switch Is Pressed	Zero
     MODE Switch Is Not Pressed	5
     RESET Switch Is Pressed	2.5
     RESET Switch Is Not Pressed	5

   • If the voltage is OK, check and replace the combination meter assembly. See COMBINATION METER SAFETY PAD SUB-ASSEMBLY  under REMOVAL & INSTALLATION. If the voltage is not OK, go to the next step.
2. Inspect the steering pad switch:
   • Remove the steering pad switch. Check the resistance between terminals +DP and -DP of the steering pad switch connector. See STEERING PAD SWITCH RESISTANCE  table. See CONNECTOR IDENTIFICATION .
     STEERING PAD SWITCH RESISTANCE
     
     

     Switch Condition	Resistance
     MODE Switch Is Pressed	Below 1 Ω
     MODE Switch Is Not Pressed	OPEN
     RESET Switch Is Pressed	2.2 kΩ
     RESET Switch Is Not Pressed	OPEN

   • If the resistance is OK, repair or replace the wiring harness or connector. If the resistance is not OK, replace the steering pad switch. See step  5 of COMBINATION METER SAFETY PAD SUB-ASSEMBLY under REMOVAL & INSTALLATION.

Fig 1: Identifying Multi-Information Screen Circuit

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002