FixVault
Home › Lexus › 2002 › ES 300 › Repair and Diagnosis › External Pages › Different car › Section 451 (Power Liftgate System) › Pinch Sensor › Removal

Pinch Sensor: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the trim panel from liftgate. Refer to LIFTGATE .
  4. Disconnect the pinch sensor wire harness connector.
  5. Remove the screws holding the pinch sensor to liftgate.
  6. Feed the pinch sensor wire harness out of the liftgate and remove the sensor from the vehicle.
About FixVault