Transponder Key Code Erasure
NOTE:
- Delete all other master and sub-key codes leaving the master key code to use the operation. When using the key which was used before deletion, it is necessary to register the code again.
- When any operation time described below is over, registration mode completes.
- When the next procedure is performed while the timer is working, the timer completes counting time, then the next timer starts.
There are 2 ways for erasure of transponder key code:
- Depressing Brake & Acceleration Pedals - Refer to the flowchart, see Fig 1.
- Using Hand-Held Tester - Refer to the flowchart, see Fig 2.