Evaporator Temperature Sensor: Inspection

WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE INSTRUMENT PANEL (See INSTRUMENT PANEL )
REMOVE EVAPORATOR TEMPERATURE SENSOR
1. Pull out the air duct from A/C unit.
2. Remove aspirator set bolt.
  
  Fig 1: Removing Aspirator Set Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the connector and connector clamp.
4. Using a screwdriver, pull out the sensor.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 2: Removing Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Release the 2 claws and remove the sensor from bracket plate.
  
  Fig 3: Removing Sensor From Bracket Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT EVAPORATOR TEMPERATURE SENSOR (See )
INSTALL EVAPORATOR TEMPERATURE SENSOR
INSTALL INSTRUMENT PANEL