Outer Rear View Mirror ASSY LH: Replacement

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.
On the RH side, use the same procedures as on the LH side.

REMOVE FRONT DOOR SERVICE HOLE COVER LH (See OVERHAUL )
1. Remove the front lower frame bracket garnish LH.
2. Remove the front door inside handle bezel plug LH
3. Remove the front armrest base panel upper LH.
4. Remove the power window regulator master switch.
5. Remove the front door trim board LH.
6. Remove the front door service hole cover LH.
REMOVE OUTER REAR VIEW MIRROR ASSY LH
1. Disconnect the connector.
2. Remove the 3 nuts and mirror.
Fig 1: Removing Outer Rear View Mirror Assy LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OUTER REAR VIEW MIRROR ASSY LH
1. Install the mirror with the 3 nuts.
  Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
2. Connect the connector.

Fig 2: Installing Outer Rear View Mirror Assy LH