How To Proceed With Troubleshooting

The hand-held tester can be used at steps 3, 4, 6, and 9.

1. Vehicle Brought to Workshop 
2. Customer Problem Analysis (SEE  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
3. Connect the OBD II scan tool or hand-held tester to DLC3 
4. Check and Clear DTC and Freeze Frame Data (SEE  DTC CHECK/CLEAR  ) 
5. Visual Inspection 
6. Setting the Check Mode Diagnosis (SEE  CHECK MODE PROCEDURE  ) 
7. Problem Symptom Confirmation (SEE  ROAD TEST  ) 

   Symptom does not occur: Go to step 8 

   Symptom occur: Go to step   9 

8. Symptom Simulation (SEE ) 
9. DTC Check (SEE  DTC CHECK/CLEAR  ) 

   DTC is not output: Go to step 10 

   DTC is output: Go to step   18 

10. Basic Inspection (SEE  ON-VEHICLE INSPECTION  ,  ADJUSTMENT  and  ADJUSTMENT  ) 

    NG: GO TO STEP   20 

    OK: Go to next step. 

11. Mechanical System Test (SEE  MECHANICAL SYSTEM TESTS  ) 

    NG: GO TO NEXT STEP   17 

    OK: Go to next step. 

12. Hydraulic Test (SEE  HYDRAULIC TEST  ) 

    NG: Go to step   17 

    OK: 

13. Manual Shifting Test (SEE  MANUAL SHIFTING TEST  ) 

    NG: Go to next step   15 

    OK: 

14. Problem Symptoms Table Chapter 1 (SEE  PROBLEM SYMPTOMS TABLE  ) 

    NG: Go to step   19 

    OK: 

15. Problem Symptoms Table Chapter 2 (SEE  PROBLEM SYMPTOMS TABLE  ) 

    NG: Go to next step. 

16. Part Inspection 

    Go to step   20 

17. DTC Chart (SEE  DIAGNOSTIC TROUBLE CODE CHART  ) 
18. Circuit Inspection 
19. Identification of Problem 
20. Repair 
21. Confirmation Test 

    End