Room Temperature Sensor: Inspection

WARNING: This page is about a different car, the 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.

Remove Lower Finish Panel
1. Remove the 3 screws.
2. Release the 3 claws and pull out the lower finish panel.
Remove Room Temperature Sensor
1. Disconnect the connector and aspirator hose.
2. Release the 2 claws and pull out the sensor.
  
  Fig 1: Removing Room Temperature Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Inspect Room Temperature Sensor Resistance
Measure resistance between terminals at each temperature as shown in the chart.

Fig 2: Reviewing Room Temperature Sensor Resistance Information
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If resistance is not as specified, replace the sensor.

Fig 3: Inspecting Room Temperature Sensor Resistance
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Install Room Temperature Sensor
1. Install the sensor and fit the 2 claws.
2. Connect the aspirator hose and connector.
Install Lower Finish Panel
1. Install the lower finish panel and fit the 3 claws.
2. Install the 3 screws.
Fig 4: Installing Room Temperature Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002