FixVault
Home › Lexus › 2004 › SC 430 › Repair and Diagnosis › Transmission › Automatic Trans › Servicing - A/T › Removal & Installation › Park/Neutral Position Switch › Removal

Park/Neutral Position Switch: Removal

  1. Remove 4 bolts and front floor brace center.
  2. Remove 2 bolts, left and right rear suspension member braces and frame spacers. See Figure.
  3. Remove oxygen sensor.
  4. Remove exhaust pipe using the following steps:
    1. Remove 4 bolts, nuts and 2 gaskets from exhaust manifold. See Figure.
    2. Remove exhaust pipe.
  5. Remove 4 bolts and front floor heat insulator No. 1.
  6. Separate shift rod using the following steps:
    1. Set gearshift lever to "N" position.
    2. Remove nut and disconnect rod.
  7. Remove shift lever using the following steps:
    1. Disconnect PNP switch connector.
    2. Remove nut and shift lever with shift rod.
  8. Remove PNP switch using the following steps:
    1. Pry out lock plate and remove nut.
    2. Remove bolt and pull out PNP switch. See Figure.
About FixVault