Front Axle Hub: Reassembly

1. Using SST and a press, install a new bearing to steering knuckle.

   SST 09309-36010, 09950-60020 (09951-00720), 09950-70010 (09951-07150)

   NOTE: If the inner race and balls come loose from the bearing outer race, make sure to install them on the same side as before.
   Fig 1: Installing New Bearing To Steering Knuckle

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using snap ring pliers, install a new snap ring.

1. Install the inner race (outside).
2. Using SST and a hammer, install a new oil seal until it is flush with the end surface of the steering knuckle.

   SST 09608-32010

3. Coat MP grease to the oil seal lip.

1. Install the brake dust cover to the steering knuckle with the 4 bolts.

   Torque: 8.3 N.m (85 kgf.cm, 74 in.lbf) 

   Fig 2: Installing New Oil Seal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, install the axle hub to the steering knuckle.

   SST 09316-60011 (09316-00011, 09316-00071), 09608-32010

   Fig 3: Installing Axle Hub To Steering Knuckle

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install a new axle hub lock nut.

   Torque: 199 N.m (2,030 kgf.cm, 147 ft.lbf) 

2. Using a chisel and hammer, stake the lock nut.

Using a screwdriver and hammer, install the grease cap to the steering knuckle.