FixVault
Home › Lexus › 2005 › RX 330 AWD › Repair and Diagnosis › External Pages › Different car › Section 540 (Starting) › Starter › Installation

Section 540 (Starting): Starter: Installation

WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    Fig 1: Identifying Starter Assembly Bolts
    G04975667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf) 

    2. Connect the wire harness to terminal 30 and install the nut, and then attach the terminal cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the terminal 50 connector to the starter assembly.
  2. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  9. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).

      HINT:

      Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.

About FixVault