Slip Indicator Light does not Come ON: Wiring Diagram

See BRAKE WARNING LIGHT DOES NOT COME ON  .

1. INSPECT CAN COMMUNICATION SYSTEM 
   1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed To
      DTC is not output	A
      DTC is output	B

      B : REPAIR CAN COMMUNICATION SYSTEM 

      A : GO TO NEXT STEP 

2. INSPECT MULTIPLEX COMMUNICATION SYSTEM 
   1. Check if the multiplex communication system DTC is output (See DTC CHECK / CLEAR ).

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed To
      DTC is not output	A
      DTC is output	B

      B : REPAIR MULTIPLEX COMMUNICATION SYSTEM 

      A : GO TO NEXT STEP 

3. REPLACE SLIP INDICATOR LIGHT 
   1. Connect the intelligent tester to the DLC3.
   2. Start the engine.
   3. Select the "SLIP INDI LAMP" in the ACTIVE TEST and operate the SLIP indicator light by the intelligent tester.

      ACTIVE TEST: ABS/VSC 

      ACTIVE TEST - ABS/VSC
      
      

      Item (Display)	Vehicle Condition / Test Details	Diagnostic Note
      SLIP INDI LAMP	Turn SLIP indicator light ON / OFF	Observe combination meter

   4. Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using the intelligent tester.

      OK: 

      The SLIP indicator light turns on or off in accordance with the intelligent tester. 

      HINT:

      If troubleshooting has been carried out according to the problem symptoms table, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

      NG : Go to step 4 

      OK : REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY 

4. INSPECT COMBINATION METER ASSEMBLY 
   1. Check the combination meter assembly (See REMOVAL ).

      HINT:

      If troubleshooting has been carried out according to the problem symptoms table, refer back to the table and proceed to the next step (See PROBLEM SYMPTOMS TABLE  ).

      NG : REPLACE COMBINATION METER ASSEMBLY 

      OK: END