Height Control Dryer: Installation
WARNING: This page is about a different car, the 2007 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL HEIGHT CONTROL DRYER ASSEMBLY
- Install the bolt, the dryer and a new O-ring.
Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf)
- Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.
Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
- Install the height control compressor assembly to the bracket with the 3 bolts.
Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf)
- Connect the connector.
- Install the bolt, the dryer and a new O-ring.
- CONNECT HEIGHT CONTROL TUBE NO. 2 (See INSTALLATION )
- INSTALL HEIGHT CONTROL FILTER (See INSTALLATION )
- INSTALL HEIGHT CONTROL COMPRESSOR COVER (See INSTALLATION )
- CHECK AIR LEAK
HINT:
See ADJUSTMENT
- INSTALL FUEL TANK FILLER PIPE PROTECTOR (See INSTALLATION )
- INSTALL QUARTER PANEL MUDGUARD REAR LH
- INSTALL REAR DISC WHEEL
Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)