Combination Meter: Removal

WARNING: This page is about a different car, the 2006 Lexus GS 430 and 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING COLUMN COVER UPPER
For 3GR-FSE (see REMOVAL )

For 3UZ-FE (see REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Using a screwdriver, detach the 5 clips.
  HINT:
  
  Tape the screwdriver tip before use.
2. Remove the cluster finish panel and then disconnect the connector.
  
  Fig 1: Identifying Cluster Finish Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
2. Disconnect the connector and remove the combination meter.
  
  Fig 2: Locating Combination Meter Mounting Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER GLASS
1. Using a screwdriver, detach the 2 claws and open the cover.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Opening Cover And Detaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 3 connectors.
  
  Fig 4: Identifying Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Detach the 7 claws and remove the glass.
  
  Fig 5: Identifying Glass And Detaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002