Navigation Ecu: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart. (See SPECIFIED TORQUE FOR STANDARD BOLTS )

1. INSTALL NO. 2 DISC PLAYER BRACKET 
   1. Install the bracket's aligning protrusions labeled A to the ECU.
   2. Install the 2 screws labeled B.
      Fig 1: Identifying No. 2 Disc Player Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 DISC PLAYER BRACKET 
   1. Install the bracket's aligning protrusions labeled A to the ECU.
   2. Install the 2 screws labeled B.
      Fig 2: Identifying No. 1 Disc Player Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL NAVIGATION ECU WITH DISC PLAYER BRACKET 
   1. Install the navigation ECU with bracket with the 3 bolts.
   2. Connect the connectors.
4. INSTALL GLOVE COMPARTMENT DOOR SUBASSEMBLY (See  INSTALLATION  ) 
5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See  INSTALLATION  ) 
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
7. INSTALL INSTRUMENT SIDE PANEL RH (See  INSTALLATION  ) 
8. INSTALL FRONT DOOR OPENING TRIM COVER RH (See  INSTALLATION  ) 
9. INSTALL FRONT DOOR SCUFF PLATE RH (See  INSTALLATION  ) 
10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See  INSTALLATION  ) 
11. INSTALL CONSOLE UPPER PANEL ASSEMBLY (See  INSTALLATION  ) 
12. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See  INSTALLATION  ) 
    Fig 3: View Of ECU And Bolts

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
14. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
15. CHECK SRS WARNING LIGHT 
    1. Check SRS warning light (See PRECAUTION ).