Seat Position Sensor: Replacement

WARNING: This page is about a different car, the 2007 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.

See PRECAUTION
SEPARATE BATTERY NEGATIVE TERMINAL (See PRECAUTION )
REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH (SEE REMOVAL )
REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH (SEE REMOVAL )
REMOVE SEAT TRACK COVER RH (SEE REMOVAL )
REMOVE SEAT TRACK COVER RH (SEE REMOVAL )
REMOVE FRONT SEAT ASSY LH (SEE REMOVAL )
REMOVE SEAT POSITION AIR BAG SENSOR

Fig 1: Identifying Bolt Of Seat Position Airbag Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector of the seat position airbag sensor.
2. Remove the bolt and seat position airbag sensor.
INSTALL SEAT POSITION AIR BAG SENSOR

Fig 2: Identifying New Bolt Of Seat Position Airbag Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the seat position airbag sensor with a new bolt.
  Part No.:
  
  Bolt: 90119-06871
  
  Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
2. Connect the connector of the seat position airbag sensor.
  NOTE:
  - Installation of the connector is done with the sensor assy installed. Make sure the sensor assy is installed with the specified torque.
  - If the sensor assy has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assy with a new one.
  - When installing the sensor assy, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
  - After installation, shake the sensor assy to check that there is no looseness.
INSTALL FRONT SEAT ASSY LH (SEE INSTALLATION )
INSPECT SRS WARNING LIGHT (SEE DIAGNOSIS SYSTEM )