FixVault
Home › Lexus › 2006 › IS 250 AWD › Repair and Diagnosis › Accessories & Equipment › Exterior Lights › Lighting › Height Control Sensor › Installation

Height Control Sensor: Installation

  1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY 
    1. When replacing the rear height control sensor subassembly:
      1. Align matchmarks and also the trace of the nut, and install the rear height control sensor sub-assembly and bracket.
    2. When reusing the rear height control sensor subassembly:
      1. Align matchmarks on the rear height control sensor sub-assembly and bracket.
    3. Install the rear height control sensor sub-assembly with the 2 bolts and nut.
      Fig 1: Aligning Matchmarks On Rear Height Control Sensor Sub-Assembly & Bracket
      G04049654Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

      Torque: Bolt 

      14 N*m (143 kgf*cm, 10 ft.*lbf) 

      Nut 

      5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Install the clamp.
    5. Connect the connector.
      Fig 2: Identifying Clamp
      G04049655Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  2. REMOVE FRONT HEIGHT CONTROL SENSOR SUBASSEMBLY (for 4WD) 
    1. Install the 2 bolts.

      Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf) 

      Fig 3: Identifying Bolts
      G04049656Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    2. Install the front height control sensor sub-assembly with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    3. Connect the connector.
      Fig 4: Identifying Front Height Control Sensor Sub-Assembly With Bolt
      G04049657Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  3. INSTALL FRONT HEIGHT CONTROL SENSOR SUBASSEMBLY (for 2WD) 
    1. Install the 2 bolts.
      Fig 5: Identifying Bolts
      G04049658Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

      Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf) 

    2. Install the front height control sensor sub-assembly with the nut.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    3. Connect the connector.
  4. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT (See  ADJUSTMENT   ) 
  5. PREPARATION FOR HEADLIGHT AIMING (Using a tester) (See Step 2 in  ADJUSTMENT   ) 
  6. PREPARATION FOR HEADLIGHT AIMING (Using a screen) (See Step 3 in  ADJUSTMENT   ) 
  7. HEADLIGHT AIMING INSPECTION (See Step 4 in  ADJUSTMENT   ) 
  8. HEADLIGHT AIMING ADJUSTMENT (See Step 5 in  ADJUSTMENT   ) 
Fig 6: Identifying Front Height Control Sensor Sub-Assembly With Nut
G04049659Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
About FixVault