FixVault
Home › Lexus › 2006 › IS 250 AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 3 (Automatic Transmission (A960E)) › Pattern Select Switch › Inspection

Pattern Select Switch: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT PATTERN SELECT SWITCH 
    1. Measure the resistance according to the value(s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION CHART

    Switch Condition Tester Connection Specified Condition
    Pattern select switch (PWR) 3 - 7 Below 1 Ω
    Pattern select switch (NORM) 3 - 7 10 kΩ or higher
    Press continuously Pattern select switch (SNOW) 1 - 3 Below 1 Ω
    Release Pattern select switch (SNOW) 1 - 3 10 kΩ or higher
    Fig 1: Inspecting Pattern Select Switch
    G04045915Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the resistance value is not as specified, replace the pattern select switch.

About FixVault