FixVault
Home › Lexus › 2006 › IS 350 › Repair and Diagnosis › External Pages › Different car › Section 17 (Transfer) › Transfer Valve Body Assembly › Removal

Transfer Valve Body Assembly: Removal

WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN AUTOMATIC TRANSMISSION FLUID (See  AUTOMATIC TRANSMISSION (A760H) or AUTOMATIC TRANSMISSION (A960E)  ) 
  2. REMOVE REAR NO. 1 FLOOR PANEL BRACE (See  REMOVAL  ) 
  3. REMOVE FRONT CENTER FLOOR BRACE (See Step 2 in  REMOVAL  ) 
  4. DISCONNECT HEATED OXYGEN SENSOR (See Step 3 or 4 in  REMOVAL  ) 
  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (See Step 5 in  REMOVAL  ) 
  6. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR (See Step 2 in  REMOVAL  ) 
  7. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (See  AUTOMATIC TRANSMISSION (A760H) or AUTOMATIC TRANSMISSION (A960E)  ) 
  8. REMOVE ENGINE REAR MOUNTING MEMBER (See Step 8 in  REMOVAL   ) 
  9. REMOVE TRANSFER DYNAMIC DAMPER (See Step 9 in  REMOVAL   ) 
  10. REMOVE TRANSFER OIL PAN (See Step 10 in  REMOVAL   ) 
  11. REMOVE TRANSFER VALVE BODY ASSEMBLY 
    1. Remove the 4 bolts and the transfer upper valve body.
    2. Disconnect the transfer wire connector from the transfer control solenoid.
    Fig 1: Removing Transfer Valve Body Assembly
    G04046850Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE TRANSFER CONTROL SOLENOID (See Step 31 in  DISASSEMBLY   ) 
About FixVault