Service Check Mode (DTC Clear/Recheck)

HINT:

Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.

1. Enter the diagnostic mode (See  DIAGNOSTIC START-UP/FINISH   ). 
2. Clear DTC 
   1. Press the "Code CLR" switch for 3 seconds.
      Fig 1: Pressing "Code CLR" Switch

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Check result is cleared.
      Fig 2: Checking Result Cleared

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Recheck 
   1. Press the "Recheck" switch.
   2. Confirm that all diagnostic codes are "OK" when the check results are displayed.

      If a code other than "OK" is displayed, troubleshoot again.

      Fig 3: Confirming Diagnostic Codes Are "OK"

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Press the "LAN Mon" switch to change to "LAN Monitor" mode.
      Fig 4: Pressing "LAN Mon" Switch

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Confirm that all diagnostic codes are "No Err".

   If a code other than "No Err" is displayed, troubleshoot again.

   Fig 5: Confirming All Diagnostic Codes Are "NO Err"

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002