Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was LEAN or RICH, and other data from the time the malfunction occurred.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2119) 

   Result: 

   DTC OUTPUT DESCRIPTION
   
   

   Display (DTC output)	Proceed to
   Only P2119 is output	A
   P2119 and other codes are output	B

   1. B: Go to RELEVANT DTC TABLE (See  DIAGNOSTIC TROUBLE CODE TABLE   ) 
   2. A: Go to next step. 
2. CHECK IF DTC OUTPUT REOCCURS 
   1. Clear the DTC (see DTC CHECK/CLEAR  ).
   2. Allow the engine to idle for 15 seconds.
   3. Depress the parking brake and move the shift lever to D.
   4. Depress the brake pedal securely and the accelerator pedal fully for 5 seconds.
   5. Read the DTC.

      HINT:

      Actual throttle position sensor voltage can be confirmed using the hand-held tester by entering the following menus: DATA LIST / ALL / THROTTLE POS #1.

      OK: No DTC output. 

   1. NG: REPLACE THROTTLE BODY ASSY (See  REPLACEMENT  ) 
   2. OK: NORMAL