FixVault
Home › Lexus › 2007 › ES 350 › Repair and Diagnosis › Body & Frame › Door Locks › Door Lock › Front Door Lock › Installation

Front Door Lock: Installation

  1. INSTALL FRONT DOOR LOCK ASSEMBLY 
    NOTE:
    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This may result in a malfunction of the front door lock assembly.
    1. Install the front door inside locking cable assembly.
      Fig 1: Identifying Front Door Lock Assembly LH
      G05252793Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 3 claws.
      Fig 2: Identifying Front Door Lock Assembly Claws
      G05252792Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the front door lock remote control cable assembly.
    4. Apply MP grease to the sliding parts of the front door lock assembly.
    5. Install a new door lock wiring harness seal to the front door lock assembly.
      Fig 3: Identifying Front Door Lock Remote Control Cable Assembly
      G05252791Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Insert the front door lock open rod to the front door lock assembly, and set it to the front door outside handle frame.
    7. Make sure that the front door lock open rod is securely connected to the front door lock assembly.
    8. Using a "TORX" socket wrench (T30), install the front door lock assembly with the 3 screws.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    9. Connect the connector.
      10. Fig 4: Installing Front Door Lock Assembly
      G05252802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER  (See REASSEMBLY )
  3. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY  (See REASSEMBLY )
  4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY  (See REASSEMBLY )
  5. INSTALL FRONT DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  6. INSTALL FRONT NO. 1 DOOR TRIM BRACKET  (See REASSEMBLY )
  7. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY  (See INSTALLATION )
  8. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP  (See REASSEMBLY )
  9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  10. INSTALL DOOR ARMREST COVER  (See REASSEMBLY )
  11. INSTALL COURTESY LIGHT ASSEMBLY  (See REASSEMBLY )
  12. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY  (See REASSEMBLY )
  13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )
About FixVault