Drive Belt: Installation

1. Install the V-ribbed belt.
2. While turning the belt tensioner counterclockwise, remove the bar.
   Fig 1: Releasing Belt Tension

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. If it is difficult to install the V-ribbed belt, perform the following procedure:
   1. Put the V-ribbed belt on every pulley except the tensioner pulley as shown in the illustration.
   2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
      NOTE:

      • Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      • Check that the V-ribbed belt is properly set to each pulley.
   Fig 2: View Of Drive Belt Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)