FixVault
Home › Lexus › 2007 › ES 350 › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel › Fuel Pressure Pulsation Damper › Removal

Fuel Pressure Pulsation Damper: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE 

    HINT:

    See PRECAUTION  .

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. DRAIN ENGINE COOLANT  (See COOLANT )
  4. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  5. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  6. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  7. REMOVE FRONT SUSPENSION CENTER UPPER BRACE 
  8. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See ON-VEHICLE INSPECTION )
  10. REMOVE INTAKE AIR SURGE TANK ASSEMBLY (See  REMOVAL   ) 
  11. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Remove the clip.
    2. Pull out the fuel pressure pulsation damper from the fuel delivery pipe.
    3. Remove the O-ring from the fuel pressure pulsation damper.
      Fig 1: Identifying Fuel Pressure Pulsation Damper, Clip And O-Ring
      G04975030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault