FixVault
Home › Lexus › 2007 › GS 350 AWD › Repair and Diagnosis › Engine Performance › Ignition System › Ignition (2GR-FSE) › Ignition Coil › Installation

Ignition Coil: Installation

  1. INSTALL IGNITION COIL ASSEMBLY 
    1. Install the 6 ignition coils with the 6 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the 6 ignition coil connectors.
      Fig 1: Locating Ignition Coils With Bolts
      G05287691Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Attach the 3 wire harness clamps and connect the noise filter connector.
      Fig 2: Locating Wire Harness Clamps And Filter Connector
      G05287690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See  INSTALLATION  ) 
  3. INSTALL NO. 2 VENTILATION HOSE (See  INSTALLATION  ) 
  4. INSTALL V-BANK COVER (See  INSTALLATION  ) 
  5. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  6. INSTALL ENGINE ROOM SIDE COVER RH (See  INSTALLATION  ) 
  7. INSTALL COOL AIR INTAKE DUCT SEAL (See  INSTALLATION  ) 
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
About FixVault