FixVault
Home › Lexus › 2007 › GS 350 AWD › Repair and Diagnosis › External Pages › Different car › Section 1 (Automatic Transaxle) › Floor Shift Assembly › Removal

Floor Shift Assembly: Removal

WARNING: This page is about a different car, the 2007 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (See  REMOVAL  ) 
  3. REMOVE CONSOLE UPPER PANEL ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See  REMOVAL  ) 
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See  REMOVAL  ) 
  6. REMOVE CONSOLE BOX PLATE (See  REMOVAL  ) 
  7. REMOVE CONSOLE BOX REGISTER ASSEMBLY (See  REMOVAL  ) 
  8. REMOVE CONSOLE BOX (See  REMOVAL  ) 
  9. REMOVE NO.2 CONSOLE BOX DUCT (See  REMOVAL  ) 
  10. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    (See INSTALLATION )

  11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1 (See  REMOVAL  ) 
  12. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Remove the nut and separate the floor shift gear shifting rod sub-assembly.
      Fig 1: Locating Floor Shift Gear Shifting Rod Nut
      G05295396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE FLOOR SHIFT ASSEMBLY 
    1. Disconnect the connectors.
    2. Remove the 4 bolts.
    3. Remove the floor shift assembly.
      Fig 2: Locating Floor Shift Assembly Bolts
      G05288268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault