DTC C1256/57 Accumulator Low Pressure: Description
The accumulator pressure sensor is built into the actuator and detects the accumulator pressure.
The skid control ECU turns on the brake control warning light and sounds the skid control buzzer if it senses a decrease in the accumulator pressure.
DTC DETECTING CONDITION CHART
| DTC No. |
Information Code |
DTC Detection Condition |
Trouble Area |
| C1256/57 |
141 |
When either of the following is detected:
- When inputting the vehicle speed, the brake operation is input with the accumulator pressure decreased or the accumulator pressure extremely decreases while braking for 0.3 seconds or more.
- The accumulator pressure has been low since system start and the pressure is less than 14.62 MPa for 0.8 seconds.
|
- Brake actuator assembly
- Skid control ECU
|
| ↑ |
143 |
When any of the following is detected:
- When inputting the vehicle speed, any of the wheel cylinder pressure sensor values is lower than the specified value with the accumulator pressure low for 0.5 seconds or more.
- The accumulator pressure decreases without increasing the wheel cylinder pressure of each wheel.
- With the motor relay abnormal or off, the accumulator pressure is less than 14.62 MPa for 0.5 seconds or more.
|
↑ |