FixVault
Home › Lexus › 2007 › GS 430 › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt › Seat Belt Control Ecu › Removal

Seat Belt Control Ecu: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (See  REMOVAL  ) 
  3. REMOVE TOOL BOX (See  REMOVAL  ) 
  4. REMOVE REAR FLOOR FINISH PLATE (See  REMOVAL  ) 
  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT (See  REMOVAL  ) 
  6. REMOVE LUGGAGE COMPARTMENT TRIM SIDE COVER INNER LH (See  ADJUSTMENT  ) 
  7. REMOVE SEAT BELT CONTROL ECU 
    1. Remove the 3 nuts and disconnect ECU.
      Fig 1: Installing ECU Nuts
      G05298548Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector.
    3. Remove the nut.
    4. Detach the claw and remove the ECU.
    Fig 2: Installing ECU
    G05298549Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault