FixVault
Home › Lexus › 2007 › GS 450h › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Audio/Visual › Network Gateway Ecu › Installation

Network Gateway Ecu: Installation

  1. INSTALL NETWORK GATEWAY ECU 
    1. Install the ECU.
    2. Attach the 2 claws to install the cover.
    3. Connect the ECU connector.
      Fig 1: Locating Network Gateway ECU
      G05311505Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL INSTRUMENT SIDE PANEL RH  (See INSTALLATION )
  6. INSTALL FRONT DOOR OPENING TRIM COVER RH  (See INSTALLATION )
  7. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  9. INSTALL CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSPECT STEERING PAD  (See INSTALLATION )
  13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  14. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).
About FixVault