Steering Pad Switch: Installation

INSTALL STEERING PAD SWITCH LH
1. Hold the connector cover and connect the switch to the steering pad switch cable.
  
  Fig 1: Connecting Switch To Steering Pad Switch Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 2 claws and close the connector cover.
  
  Fig 2: Attaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Attach the steering pad switch cable's tabs to the switch, as shown in the illustration.
  
  Fig 3: Attaching Steering Pad Switch Cable Tabs To Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Attach the clip and 2 claws to install the switch.
5. Install the screw.
6. Connect the switch connectors.
  
  Fig 4: Locating Clip And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD SWITCH RH
1. Hold the connector cover and connect the switch to the steering pad switch cable.
  
  Fig 5: Connecting Switch To Steering Pad Switch Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 2 claws and close the connector cover.
  
  Fig 6: Attaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Attach the steering pad switch cable's tabs to the switch, as shown in the illustration.
  
  Fig 7: Attaching Steering Pad Switch Cable Tab To Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Attach the clip and 2 claws to install the switch.
5. Install the screw.
  
  Fig 8: Attaching Clip And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
INSTALL NO. 2 STEERING WHEEL COVER LOWER
INSTALL NO. 3 STEERING WHEEL COVER LOWER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT STEERING PAD (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).