Power Seat Switch: Installation

HINT:

• Use the same procedures for the LH and RH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL FRONT POWER SEAT SWITCH 
   1. Connect the connector.
   2. Install the switch with the 3 screws.
2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY 
   1. Connect the connector to the front power seat lumbar switch.
   2. Attach the claw and install the cushion shield assembly.
   3. Install the 5 screws.
      Fig 1: Identifying Screws And Claws On No. 1 Front Cushion Shield With Cushion Shield Inner

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Connect the 2 rubber bands of the front seatback board to the seat frame.
3. INSTALL RECLINING POWER SEAT SWITCH KNOB 
4. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB 
5. INSTALL FRONT SEAT OUTER BELT ASSEMBLY 
   1. Move the seat using the power seat switch knob so that the seat belt anchor bolt is revealed.
   2. Install the front seat outer belt anchor with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

   3. Install the seat belt anchor cover cap.
   4. Install the front seat belt hole cover.
      Fig 2: Identifying Front Seat Outer Belt Anchor With Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002