Front Axle Hub: Removal

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

CAUTION: When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid pressure may increase.

TURN POWER SWITCH OFF
1. Turn the power switch OFF, and check that the "READY" indicator turns off.
REMOVE FRONT WHEEL
DISCONNECT FRONT SPEED SENSOR CONNECTOR LH
NOTE:
- Be careful not to damage the speed sensor.
- Prevent foreign matter from adhering to the speed sensor.
  
  Fig 1: Locating Front Speed Sensor Connector LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
1. Remove the 2 bolts and disconnect the brake caliper.
  NOTE: Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.
  
  Fig 2: Locating Brake Caliper Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the caliper plates from the brake caliper.
REMOVE FRONT DISC (See DISASSEMBLY )
REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
1. Remove the 4 bolts, front axle hub and front disc brake dust cover.