FixVault
Home › Lexus › 2007 › GS 450h › Repair and Diagnosis › Engine Mechanical › Auxiliary Emission Control Systems › Emission Control › Heated Oxygen Sensor › Installation

Heated Oxygen Sensor: Installation

  1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
    1. Using SST, install the sensor to the front exhaust pipe.

      SST 09224-00010 

      Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST 

      44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST 

      Fig 1: Identifying Torque Wrench With Fulcrum Length
      G05303414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      • Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
      • Make sure SST and wrench are connected in a straight line.
    2. Pass the sensor connector through the floor panel and install the grommet.
    3. Connect the sensor connector.
      Fig 2: Identifying Sensor Connector And Grommet (Bank 2 Sensor 2)
      G05303412Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Using SST, install the sensor to the front exhaust pipe.
      Fig 3: Identifying Torque Wrench With Fulcrum Length
      G05303416Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      SST 09224-00010 

      Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST 

      44 N*m (449 kgf*cm, 32 ft.*lbf) for not use without SST 

      HINT:

      • Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
      • Make sure SST and wrench are connected in a straight line.
    2. Pass the sensor connector through the floor panel and install the grommet.
    3. Connect the sensor connector.
  3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  5. INSTALL CONSOLE BOX PLATE  (See INSTALLATION )
    Fig 4: Identifying Sensor Connector And Grommet (Bank 1 Sensor 2)
    G05303410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
  7. INSTALL FRONT CONSOLE UPPER GARNISH  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. INSTALL SERVICE PLUG GRIP  (See INSTALLATION )
  10. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
About FixVault