DTC Check / Clear

1. Connect the intelligent tester to the DLC3.
   1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).
2. Turn the ignition switch to ON.
3. Read the DTCs by following the prompts on the tester screen.

   HINT:

   Refer to the for further details.

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to ON.
3. Operate the intelligent tester to erase the codes.

HINT:

Refer to the for further details.