Inspection Procedure

Fig 1: Identifying R1 & R3 Receiver Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the R1 and R3 receiver connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RADIO RECEIVER ASSEMBLY
   
   

   Tester Connection	Condition	Specified Condition
   R1-5 (ATX+) - R1-15 (ATX-)	Always	60 to 80 Ω
   R3-9 (TX+) - R3-10 (TX-)	Always	60 to 80 Ω

NG: REPLACE RADIO RECEIVER ASSEMBLY 

OK: Go To Next Step 

Fig 2: Identifying AVC-LAN Wiring Diagram

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

For details of the connectors, refer to TERMINALS OF ECU  .

1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
   1. Disconnect all connectors in all AVC-LAN circuits.
   2. Check for an open or short in all AVC-LAN circuits.

      OK: There is no open or short circuit. 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE